CMCC XR30
Specifications§

- Processor
- MediaTek MT7981B, aarch64, 1300 MHz
- Flash memory
- 128 MB NAND
- RAM
- 512 MB DDR4
- Ethernet
- 3 × 1G LAN + 1 × 1G WAN
- USB
- 1 × USB 3.0
- Wi-Fi chip
- MediaTek MT7976CN
- Wi-Fi 5 GHz
- AX, 160MHz, 2x2, 2402MB/s, 1024QAM
- Wi-Fi 2.4 GHz
- AX, 40MHz, 2x2, 574MB/s, 256QAM
Build features§
- FunctionalityExcept:
Cloud services
Components - Factory resetWith the Reset button
- WPS buttonConfigured as Wi-Fi
- Mesh buttonYes
- LEDSystem
Internet connected - Mesh compatibilityWith original devices and clones
- Built-in storage70.9 MB, Entware can be installed
Preparing for flashing§
- Download and unpack the firmware archive In the panel under the device name, pick your system: Windows, macOS or Linux. Starting the installer on macOS and Linux.
- Connect the router to the computer with a cable (Ethernet) Flashing over Wi-Fi is not possible.
Installing from OpenWrt§
- Uploading the image In the OpenWrt web interface, upload
rax3000m-me-openwrt.itbas an update (sysupgrade). - Flashing After the reboot, run
CMCC_XR30_flasher, click “Install” and wait until it finishes. - System start The device starts in about 3 minutes.
Done!
Router access
- Web interface
- 192.168.1.1
- Login
admin- Password
12345678- Wi-Fi password
12345678
Updating the firmware§
To update, use the Athena bootloader or KeenKit.
Since version 5.0.7 the firmware can also be updated through the web interface.
Reverting to stock firmware§
The revert is done from a full backup through the Athena bootloader. The steps are in the instructions for MT7981.