Netis NX32U/Netis N6v2
Specifications§

- Processor
- MediaTek MT7981B, aarch64, 1300 MHz
- Flash memory
- 128 MB NAND
- RAM
- 256 MB DDR3
- Ethernet
- 3 × 1G LAN + 1 × 1G WAN
- USB
- 1 × USB 3.0
- Wi-Fi chip
- MediaTek MT7976CN
- Wi-Fi 5 GHz
- AX, 160MHz, 2x2, 2402MB/s, 1024QAM
- Wi-Fi 2.4 GHz
- AX, 40MHz, 2x2, 574MB/s, 256QAM
Build features§
- FunctionalityExcept:
Cloud services
Components - Factory resetWith the Reset button
- Mesh buttonYes
- LEDsYes
- Mesh compatibilityWith original devices and clones
- Built-in storage70.9 MB, Entware can be installed
- Modem rebootWorks without a hardware mod
Preparing for flashing§
- Download and unpack the firmware archive In the panel under the device name, pick your system: Windows, macOS or Linux. Starting the installer on macOS and Linux.
- Connect the router to the computer with a cable (Ethernet) Flashing over Wi-Fi is not possible.
Installing from stock firmware§
- Reset and setup Reset the router, go through the initial setup and set a password for the web interface.
- Running the script Run
Netis_NX32U_flasherand enter the password you set. - Backups Before the installation, system backups are created in the script's folder — keep them in a safe place.
- Flashing Confirm the firmware installation and wait until it finishes.
After the reboot the device starts
Done!
Router access
- Web interface
- 192.168.1.1
- Login
admin- Password
12345678- Wi-Fi password
12345678
Reducing RAM usage (optional)
To reduce RAM usage, you can turn off WHNAT hardware acceleration — more details. Enter the commands in the router's CLI one at a time:
Enter one command at a time
interface WifiMaster1 no whnatsystem configuration save
Updating the firmware§
To update, use the Athena bootloader or KeenKit.
Since version 5.0.7 the firmware can also be updated through the web interface.
Reverting to stock firmware§
The revert is done from a full backup through the Athena bootloader. The steps are in the instructions for MT7981.